Also a side question about this setup - the duplexer has a high and a low port, the CDR500700 manual does not label these ports so I had to assume by the pictures that I connected them correctly.
Motorola Cdr700 Repeater Configuration Software Piracy AndMaking a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity.The same goes for any private transaction via Private Message.Even if you attempt to engage in this activity in PMs we will still enforce the forum rules.
Motorola Cdr700 Repeater Configuration Manual Does NotYour PMs are not private and the administration has the right to read them if theres a hint to criminal activity. If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. To obtain Motorola software see the Sticky in the Motorola forum. The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Motorola Cdr700 Repeater Configuration Series Or IndividualTypically each series or individual radio requires its own software package. Often the Kenwood software is less than 100 so dont be a cheapskate; just purchase it. For MA ComHarrisGE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The conventional package is more reasonable though is still several hundred dollars. ![]() We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. For a better experience, please enable JavaScript in your browser before proceeding. I got it setup to repeat on the same frequency but got a constant tone from the TX radio every time the RX radio received. ![]() I swapped the radios, no change. I removed the repeater and duplexer and connected the radio directly to an antenna, still no change. Something is keeping the radio from breaking squelch unless I manually do it. I get no light on the RX radio when it receives, even when it is unsquelched. ![]() I thought I had saved the default cps but apparently I didnt. I am testing on an unused channel (464.475). As I had said I swapped radios to see if it was a receive issue as the othr radio was set for TX only but both radios do the same thing, no receive, (unless I unsquelch) and no RX light at all.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |